Monthly Archives: August 2015

OMRON D6T

Introduction

Just playing around with a temperature sensor and arduino board.

Hardware

Arduino Mega
Omron D6T
32×32 RGB panel

Connection scheme

Here are the pin connections between LED panel connector and Arduino:

Panel Pin Label Panel Connector Pin # Arduino Pin Notes
R0 1 2 Red data (columns 1-16)
G0 2 3 Green data (columns 1-16)
B0 3 4 Blue data (columns 1-16)
GND 4 GND Ground
R1 5 5 Red data (columns 17-32)
G1 6 6 Green data (columns 17-32)
B1 7 7 Blue data (columns 17-32)
GND 8 GND Ground
A 9 A0 Demux input A0
B 10 A1 Demux input A1
C 11 A2 Demux input A2
D 12 A3 Demux input E1, E3 (32×32 panels only)
CLK 13 11 LED drivers’ clock
STB 14 10 LED drivers’ latch
OE 15 9 LED drivers’ output enable
GND 16 GND Ground

 

Panel connector pin numbering convention: Pin 1 is top left (R0), pin 2 is to the right of pin 1, pin 3 is below pin 1, pin 4 is to the right of pin 3, etc. Pin 16 is the bottom right.

Files

code